canneed-mder-10-multi-station-digital-enamel-rater-for-ends.png

Applications

Place ends into the opening hole of ten-hole fixing holders. After the ends are pressed, turn the ten-hole fixing holders over. The current values (mA) of each end as well as the maximum current value and average value can be read out in 4 seconds. If any test failure resulted from bad connection between the contacts, the corresponding position number of the ends will be shown on the screen. 

Advantages

  • CanNeed-MDER-10 can finish testing the current of 10 ends in 4 seconds. If connected with two ten-hole fixing holders, it can test 20 ends at one time
  • High efficiency,efficiency raised by 66%
  • The data can be transmitted to the computer via RS232 C

Technical Parameter

  • Measuring Voltage: 6.3 V
  • Measuring Range: 0-300mA
  • Resolution: 0.01mA
  • Accuracy: +/- 5%
  • Data Port: RS232C
  • Dimension:L700*W370*H300mm